Permanent Magnetic Lifter Manufacturers in Ahmedabad, Gujarat

Rudra Equipment manufactures permanent magnetic lifters in Ahmedabad, Gujarat, in eight models from RE-100 to RE-5000, with lifting capacities from 100 kg to 5,000 kg. Each model holds a safety margin of 3× — the maximum breakaway force runs from 300 kg on the RE-100 to 12,500 kg on the RE-5000.

A permanent magnetic lifter grips a steel plate or block with no power supply, so a load can be lifted, moved and released by a single lever — on a crane, hoist or forklift.

Permanent Magnetic Lifter — Frequently Asked Questions

It uses permanent magnets, switched on and off with a lever, to grip flat or round steel. Because the magnets are permanent, the lifter holds the load without any power supply — there is nothing to fail in a power cut.

Ferrous steel only. It will not hold stainless of an austenitic grade, aluminium, brass or any non-magnetic material.

No, and this is the most common mistake. Rated capacity assumes a thick, flat, clean, machined steel surface. Thin plate, a rough or painted surface, rust, an air gap or a curved face all reduce holding force sharply. De-rate accordingly and never lift at the plate rating without checking.

No. No lifting magnet should be used to carry a load over any person, regardless of rated capacity.

The contact face must be kept clean, flat and free of burrs or rust, because holding force depends almost entirely on the quality of that contact. It should be load-tested on a regular schedule.
×
self-pic

Get In Touch

Contact Info

Phone number

9925093683

7359465955

Email address

rudraequipment73@gmail.com

info@rudraequipment.in

Address info

Office-9, Rameshwar Estate, behind Mahadev Estate, Ramol, Ahmedabad-380026, Gujarat, India

Rudra Equipment